Filter
Top Products
38
5
Try to operate your CATV converter or DBS
tuner by pressing CATV/DBS .
When your CATV converter or DBS tuner turns on or off, you
have entered the correct codes.
If there are more than one code listed for your brand of
CATV converter or DBS tuner, try each one until the correct
one is entered.
Note:
You cannot use both the CATV converter and DBS tuner at the same
time.
To change the transmittable signals for
operating a VCR
1
Press and hold VCR .
2
Press VCR.
3
Enter manufacturer’s codes using buttons 1 – 9,
and 0.
4
Release VCR .
Now, you can perform the following operations on the VCR.
VCR : Turn on or off the VCR.
After pressing VCR, you can perform the following operations
on the VCR:
CH +/– : Change the channels.
1 – 9, 0, +10 (100+) : Select the channels.
10 : Function as ENTER button.
3 : Start playback.
FF : Fast-wind a tape.
REW : Rewind a tape.
7 : Stop playback or recording.
8 : Pause playback. To release it, press
33
33
3.
REC PAUSE : Press this button to enter recording
pause.
Then press 3 to start recording.
Note:
Refer also to the manual supplied with your VCR.
5
Try to operate your VCR by pressing
VCR
.
When your VCR turns on or off, you have entered the correct
codes.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
Manufacturers’ codes for CATV converter
Manufacturer Codes
GENERAL INSTRUMENT 06, 07, 08, 09, 10,
11, 12, 13, 14, 29
HAMLIN/REGAL 01, 02, 03, 04, 05
JERROLD 06, 07, 08, 09, 10,
11, 12, 13, 14
OAK 15, 16, 17
PANASONIC 18, 19, 20
PIONEER 21, 22
SCIENTIFIC ATLANTA 23, 24, 25
TOCOM 26
ZENITH 27, 28
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Manufacturer Codes
JVC 56, 57*, 67
AMSTRAD 43, 44, 45, 46, 47
BLAUPUNKT 30
ECHOSTAR 50, 51, 67
GOLDSTAR 31
GRUNDIG 32, 33
HIRSHMANN 48, 52, 53, 55
INSTRUMENT 68
ITT/NOKIA 34
KATHREIN 52, 58, 61, 62, 63
NEC 35, 36
ORBITECH 48
PHILIPS 37, 38
RCA 65
SAMSUNG 39, 40
SCHWAIGER 61, 64
SIEMENS 41, 42
SONY 66
TECHNISAT 48
Manufacturers’ codes for DBS tuner
*
“57” is the initial setting.
Manufacturers’ codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
TO BE CONTINUED TO THE NEXT PAGE
EN30-42.RX-7020V[A]3 02.4.17, 5:17 PM38