Filter
Top Products
10 – English
DESCRIPTION
Saw carriage (FIG. 2)
The saw carriage comes in the same version for all
one-man sawmill models and comprises the following
parts:
• Steel structure with runner wheels against the rails
and guides for the saw’s up and down movement.
• One screw for the saw’s vertical adjustment. The
screw is operated by a crank and is equipped with
an index plate.
• Handle with operating mechanism.
• Vibration damping plate (One-man sawmill with
chain saw engine)
• Motor console (One-man sawmill with electric motor)
• Bar and chain
• Chain oil tank for the chain (One-man sawmill with
electric motor)
A suitable chain saw is also installed on the saw
carriage.
Height Setting (FIG. 4)
The saw unit is secured vertically by a screw. A crank
(11) is fitted on the top section of the screw, and is
used to set the exact dimension of the timber
thickness. One turn of the crank moves the bandsaw
blade 5 mm. The height of the bar above the rails’
cross members is read on the scale (14). There are
two red markings on the scale that indicate the lowest
saw height with the timber support raised, one red line
for the long timber support and one red line for the
short one. CAUTION! Sawing under the respective
markings will damage the chain and there will be a risk
of sparking.
Frame (FIG. 3) and (FIG. 4)
The carriage frame consists of welded square tubing
with requisite corner reinforcement for stability during
cutting. The console is installed in the saw carriage for
the saw unit’s up and down movement. On the under-
side of the frame are four runners, fitted with bearings,
with slots for securing and smooth running along the
rails. The carriage is equipped with two adjustable
bearings, which run against the underside of the rails,
to prevent it from lifting.
FIG. 2
FIG. 3
FIG. 4
Handlebars (FIG. 4)
The saw carriage is operated and moved forwards
using handlebars (16), which are located on the left-
hand side of the saw carriage. The handlebars are
equipped with a throttle for start lock (17, 18). On the
one-man sawmill with feed, the handlebars are used
for feeding when you want to approach the end of the
log to calculate the saw yield.
16
18
17
11
14