Filter
Top Products
Installing - 5
INSTALLING
2. Insert threaded end of lift links down through holes in lift
channel (A) and bent end of lift links through holes in lift
arms (B).
3. Fasten bent ends of lift links (C) to lift arms with spring
locking pin.
4. Thread 3/8 in. nylock nut and 5/16 in. flat washer (D),
one on each side until they seat against lift channel (C).
Install Pivot Control Handle
1. Insert handle end of pivot control handle (A) through eye
bolt (B) and slide it all the way to bracket end of pivot
control handle.
2. Hook pivot release rod (C) into hole of bracket at end of
pivot control handle and fasten with spring clip (D).
3. Lay pivot control handle along side of machine onto
wheel and footrest of machine. Make sure hook of bracket
on end of pivot control handle is to the right of the eye bolt.
4. Slide 3/8 x 1 in. flat washer onto handle end of pivot
control handle and slide all the way to eye bolt.
5. Install spring locking pin (E) through pivot control handle
to hold washer against eye bolt.
6. Install rubber handle grip (F) to handle of pivot control
handle.
Install Pivot Handle Support
1. Slide eye of pivot handle support (A) onto pivot control
handle (B).
2. Insert pivot handle support through 1/2 in. hole in thrust
channel (C) and place strap over nut (D) of thrust channel.
Secure with spring locking pin (E) on opposite side of thrust
channel.
B
C
A
D
M92906
F
A
B
C
D
E
M92907
B
A
C
E
M85797
A
E
D
C