Filter
Top Products
3
Intended Use
Frontier Chippers are designed to chip natural, untreated wood only. Materials that are processed
may contain chemicals or by-products that could corrode the machine, damage the blades, or spon-
taneously combust. Frontier Equipment will not cover under warranty any chipper that has been used
for anything besides natural wood.
Serial Number
The chipper’s serial number is located on the inside of the base. This number helps us to track
changes and improvements and must be mentioned when ordering parts or requesting service. For
your convenience, a space has been provided inside the front cover of this manual to record the se-
rial number, model number, purchase date, and dealer name.
Specications
INTRODUCTION
Specications WC1103 WC1105 WC1205
Chip Opening 3 x 5.5 in. (7.5 x 14cm) 5.5 x 8 in. (14 x 20cm)
Drive System PTO PTO
Engine N/A N/A
Transport 3 Point Hitch 3 Point Hitch
HP Required 16 35+
Rotor Size 65 lbs. 165 lbs.
Knives (2) 2.5 x 3.25 x 5/16 in. (4) 2.5 x 3.25 x 5/16 in.
Knife Bolts 3/8” Recessed Head Hardened Bolts
Feed System Manual Hydraulic
Hydraulic Requirement N/A 6 GPM
Feed Roller N/A 15” (37.5cm)
Hopper Opening 25 x 18 in. (62.5 x 45cm) 28 x 28 in. (70 x 70cm)
Feed Height 38” (95cm) 41” (102.5cm) 21” (52.5cm)
Weight (lbs.) 375 650 775