Filter
Top Products
To reassemble the blade spindle, do the following:
1. Clean the spindle housing support. Remove shavings and/or burrs.
2. Rub oil on the mounting surfaces. Press the bearing races into the rotor support
(see fig. 15).
3. Apply a layer of grease to the inner ring of the bearing. Pack the bearings with
grease.
4. Carefully lubricate the oil seal and assemble it on the spindle shaft with the lip turned
down toward the blade mounting plate.
REPAIR PROCEDURES 32 FRONTIER
G
ROOMING MOWERS OPERATOR’S MANUAL
1. grease fittin
g
2. safety nut
3. pulley
4. spacer
5. oil seal
6. bearing
7. nut
8. rotor support
9. bolt
10. bearing
11. oil seal
12. spindle shaft & rotor
13. key
14. nut
15. nut
16. blade
17. bolt
18. blade bolt
Fig. 15
19. block washer