Filter
Top Products
manufacturer operator’s manual for further information on the driveline. (Note: On
older models you may need to lubricate the wheel bearings, check wheels to see if
there is a grease fitting, if so apply two or three shots of grease every 8 hours).
2. Gearbox oil level: Check gearbox oil level, it should be between
1
/
2
and
2
/
3
full. If
needed add either SAE 90 wt. or SAE 140 wt. gear oil.
Every 25 hours: Check hardware tightness; mower vibrations can loosen bolts.
Check tightness of the hardware periodically, using Table 1 as a guide
11
.
Every 50 hours:
1. Lubricate the three spindles with two or three shots of multipurpose grease (see fig.
9). The top grease fittings are easily accessible from the top of the deck by simply
removing the plastic dust guards.
2. Check belt tension
12
.
4.03 - Blade Maintenance
WARNING: To avoid possible injury always wear proper eye and hand protection
when servicing mower blade.
In order for the mower to work properly, and to always obtain a precision cut with lower
HP requirements thus keeping cost down, proper blade maintenance is important.
Blades must be kept sharp, at their original length and corners maintained. A blade
must be replaced if, due to wear or damage, its original shape has been distorted.
MAINTENANCE 23 FRONTIER
G
ROOMING MOWERS OPERATOR’S MANUAL
12
See Section 4.04 - Belt Tension.
11
See Table 1, Torque Specifications, page 30.
Fig. 9
Lubrication of the spindle shafts easily
accessible from the top of the deck.