Filter
Top Products
24 Operator’s Manual
MAINTENANCE
EVAPORATIVE EMISSION COMPONENTS:
The unit you have purchased includes the following
components that are in compliance with 2011 California
Air Resources Board Evaporative Emission Standards;
1. Fuel Hose
2. Fuel Hose Fittings
These components should be inspected on a daily basis
for cracks, leaks, and abnormal wear. If cracking, leaks
or abnormal wear has occurred, the components should
be replaced immediately.
IDLE CONTROL ADJUSTMENT:
NOTE: The automatic idle speed is set between 2550 and
2950 RPM.
The idle speed has been pre-set at the factory and
should rarely require readjustment. We recommend that
all adjustments of this nature be made by a John Deere
Customer Service Representative.
Erratic idle operation of the engine usually indicates a
need for carburetor adjustment to provide a smooth idle.
The idle control will not function properly when the idle
speed is below the recommended limits or the carburetor
is improperly adjusted.
HAVE THE UNIT SERVICED BY AN AUTHORIZED
JOHN DEERE CUSTOMER SERVICE
REPRESENTATIVE.
Service