Filter
Top Products
18 Operator’s Manual
Operation
OPERATION
NOTE: Read Operator’s Manual carefully before operating this
unit. Be certain to block the wheels to prevent the unit
from moving while operating. Always make sure the
unit is level and properly grounded. Check engine oil
before starting.
1. Turn the idle control switch to the OFF position. (See Fig.
3)
2. Move choke lever to full choke. If re-starting a warm engine,
the choke should be left in the off position. (See Fig. 4)
3. Turn the key to the START position, hold until engine starts.
4. When the engine starts, release key, allowing it to return to
the ON position.
NOTE: Do not crank the engine continuously for more than
30 seconds at a time. If the engine does not start, allow
for a 3 minute cool down period between starting
attempts. Failure to follow these guidelines can damage
the starter motor.
If the starter does not turn the engine over, shut off
the starter immediately. Do not make further attempts to
start the engine until the condition is corrected. Do not
jump start using another battery.
5. Slowly move choke lever to no choke.
6. Allow unit to run two (2) minutes to warm-up.
7. Test the GFCI receptacle(s) on the unit. Push the test button.
The reset button should pop out and there should be no
power at the receptacle. Apply a test load or lamp to each
receptacle to verify. IF THE RESET BUTTON DOES NOT
POP OUT, DO NOT USE THE RECEPTACLES(S). SEE
DEALER FOR SERVICE IMMEDIATELY.
8. If GFCI receptacle(s) test correctly, rmly push the reset
button to restore power. A distinctive click should be heard or
felt when this is complete. IF THE RECEPTACLE(S)
DO NOT RESET PROPERLY, DO NOT USE THE
RECEPTACLE(S). SEE DEALER FOR SERVICE
IMMEDIATELY.
9. Turn idle control switch to ON position. Loads can now be
applied to unit.
NOTE: This engine is equipped with a “Low Oil” shutdown
system for engine protection. The engine stops when
the oil level gets too low. The engine will not restart
without adding oil. Refer to Preparing the Generator;
Engine Fuel Capacity for instructions on adding oil.
(Fig. 3)
(Fig. 4)