Service and Maintenance
NR25796,00002C5 –19–26FEB07–2/3
Every 10 Hours
• Check engine oil level
• Check coolant level
• Drain water and sediment from fuel filter
• Lubricate tie rod ends
1
• Lubricate steering spindles
1
• Lubricate front axle pivot pin(s)
1
• Lubricate rear axle bearings
1
• Lubricate clutch pedal and right hand brake pedal.
1
• Lubricate cluch / brake shaft.
1
IMPORTANT: External lubrication is not required
for oil type rear axle
Every 50 Hours
• Check transmission-hydraulic system oil level
• Clean and check battery
• Inspect all tires
• Lubricate front axle pivot pin(s)
• Lubricate steering spindles
• Inspect tractor for loose nuts and bolts
• Lubricate clutch pedal and right hand brake pedal.
• Lubricate clutch / brake shaft.
First 100 Hours
• Change engine oil and filter
• Replace transmission-hydraulic filter
Every 250 Hours
• Service air cleaner
• Change engine oil and filter
• Clean and check battery
• Inspect and adjust alternator/fan belt
• Lubricate 3-point hitch
• Check neutral start system
• Check clutch pedal free travel
• Check brake pedal adjustment
• Replace filter inserts ( primary and secondary
alternatively)
IMPORTANT: Never replace primary and
secondary inserts simultaneously
Every 500 Hours
• Replace transmission-hydraulic filter
Every 600 Hours
• Clean engine crankcase vent tube
• Repack front wheel bearings
• Check and tighten all hoses and hose clamps
• Check cooling system for leaks
• Lubricate rear axle bearings
• Check engine idle speeds
• Have your John Deere dealer:
-Check front axle pivot pin
-Adjust engine valve clearance
Inspect fuel injectors
IMPORTANT: External lubrication is not required
for oil type rear axle
First 1100 Hours
• Change transmission-hydraulic oil and filter
Every 1250 Hours
• Change transmission-hydraulic oil and filter
• Clean transmission-hydraulic pickup screen
Annually
• Change engine oil and filter
• Replace air cleaner elements
1
Only necessary when operating in extremely wet and muddy
conditions.
90-3
022607
PN=101
Continued on next page