Filter
Top Products
Assembly
Handle Assembly
1
Assemble the handle to the handle
brackets with the four hex head cap
screws 3/8-16 x 1" long,
lockwashers 3/8" and hex locknuts
3/8-16. (See figure 3.)2
Assemble the grips to the handle.
(Soaking the grips in hot water will
aid assembly.)
Figure 3
Controls
1
Place the control rod throught he
control panel on the upper handle
and screw the threaded end of the
control rod into the ferrule on the
"L" bracket on the left side of the
chain case.
Note: Screw the control rod
through the ferrule until it extends
approximately 7/8". (See figure 4.1
2 Place the control lever through the
box on the upper handle assembly.
3
Attach the control lever to the
control panel with hex head cap
screw 5/16 x 1 Y4" long, steel
washer 5/16", rubber washer,
5/16" steel washer and hex nut
5/16". Do not over tighten. Make
sure handle moves freely. (See
figure 5.)
Figure 4
Warning: Be sure the attachment holes
on the control lever face the rear. If the
handle is assembled wrong you will not
have a neutral. (See figure 6.)
4 Place the control rod through the
attachment holes on the control
lever and secure with a cotter pin.
5 Place the control lever in the
Neutral position and pull the recoil
start handle several times. The tines
should not rotate. If they do, adjust
by screwing the control rod in or
out of the ferrule.
6
Assemble the control lever grip to
the control lever. (Soaking in hot
water will aid assembly.)
Figure
5
8