Filter
Top Products
www.clearcreekspas.com
MAINTENANCE
Spa Light
Two filters , one blue and one red, are provided with
your spa. To change the filter, simply snap the colored
filters in place on top of the normal lens. Two replace-
ment bulbs (GE#912, 12W, 12V) are also included. Put
them in a safe place for future use. When a bulb burns
out, replace it from the back of the light fitting on the
outside of the shell by pulling out the bulb receptacle.
LIGHT BULB REPLACEMENT
LOCKING
NUT
LIGHT BULB
NORMAL
LENS
COLORED
FILTER
preserve the life of your cover, you must not sit,
stand, or lie on it; nor should you place objects of
any kind on top of it.
NOTE: Jacuzzi Whirlpool Bath does not guarantee
or warrant this cover. Refer to spa cover
manufacturer's information provided with the cover.
BULB
RECEPTACLE
Cleaning Your Spa
LIGHT
BEZEL
SHELL
SPA SHOWN WITH
INSULATING
COVER
Your spa shell consists of two layers of plastic
materials. Its smooth top surface of acrylic is tough and
durable and contains concentrated color. This is sup-
ported by a substantial thickness of fiberglass-rein-
forced polyester resin. A catalyst causes a chemical
reaction during manufacture that bonds these layers
permanently into a hard, strong material. With a mini-
mum amount of care and cleaning, your whirlpool spa
will look new for years.
To clean your spa, simply use a mild, nonabrasive
liquid detergent, isopropyl alcohol, or commercially pre-
pared spa cleaner. Do not use abrasive cleaners. You
can protect and restore the gloss to a dulled surface by
applying Meguiar’s #10 Mirror Glaze, which is a product
specifically designed for use on acrylic finishes. If
Meguiar’s is not available, an acrylic polish of equal
quality or automotive paste wax will do.
Use a spa cleaner for residue buildup at the water
level of the spa surface. This may be applied to the
acrylic surface with a soft cloth and wiped clean. Use
sparingly in small amounts to avoid contaminating the
spa water. If the water line is heavily soiled, it may be
advisable to lower the water level 2-3 inches before
cleaning; then refill to normal level.
Repairs to the Acrylic
Minor scratches which do not penetrate the color
finish (acrylic) can be removed with 600-grit wet/dry
sandpaper. Restore the glossy finish with Meguiar’s #10
Mirror Glaze or comparable automotive paste wax.
Major scratches or gouges which penetrate the
acrylic surface will require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer for special instructions.
Headrest Pillows
Clean the urethane pillows regularly with soap and
water and a clean cloth. Use ARMORALL
®
or similar
protective cleaning agent once a month to maintain the
water resistance and lustrous finish. Position the head-
rest pillow at least 3" above the spa water level. Remove
the pillow from the spa if chlorine shock treatment is
used.