Filter
Top Products
2
INSTALLATION
INSTALLATION INSTRUCTIONS
Inspection and Shipping Claim
Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the
spa sustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on
the outside of the carton and immediately file a claim with the carrier.
Once the spa has been removed from the carton and before it is permanently installed (see below on this page for
unpacking instructions), check the spa completely for damage. Fill the shell with water and operate the system (see
Operating Instructions) to check for leaks which may have resulted from shipping or handling. All Jacuzzi Whirlpool
Bath spas are factory tested for proper operation and water tight connections prior to shipping. If leaks or other
problems are detected, immediately notify your Jacuzzi Whirlpool Bath dealer or Authorized Service Agent, or call
Jacuzzi Whirlpool Bath, (510)-938-7411, or (510)-938-7070 for Warranty Service.
Note: Damage or defects which could have been discovered and repaired prior to installation and which are claimed
after final installation of the spa, are excluded from our warranty.
Unpacking
the dolly for adequate support. (See Illustration B.)
The spa must not lie on its skirt.
4. When the spa has been moved to its final location,
place a 4" x 4" x 72" wooden block beside the pan side
of the spa so it is parallel with the pallet. (See
Illustration C.)
5. Tip the spa over onto its bottom with the block
supporting the spa.
6. Remove the bolts attaching pallet to spa. (See
Illustration D.)
7. Remove the pallet and carefully lower the spa to a
horizontal position at its final location.
8. Attach the loose skirt panel included in skirt box.
Record the spa serial number on the inside front
cover of this manual. (See the illustration on page 2
for the serial number location.)
Important!
Read all the instructions contained in
the Owner's Manual before beginning installation.
1. Remove the outer carton by disassembling bracing
and plastic bags. Leave the corrugated wrapping in
place on the skirt to protect the product until equip-
ment set-up.
2. Remove the box containing skirt panel and the acces-
sory package which contains the Owner's Manual,
filter cartridges, skimmer baskets, screws for skirt,
light lenses, and spare bulb . Set aside skirt panel until
equipment set-up. Put filter cartridges in a dry place
until it is time to set up the spa equipment.
3. The spa should be moved on a dolly in its upright
position while still attached to its shipping pallet. If the
pallet must be detached before the spa is moved (for
example, to allow it to pass through a door), detach it
from the pallet as instructed in steps 4 thru 7. Rein-
forcements have been installed on the spa. Note their
location at notches in the pan to the right of the
equipment door. Remove the affected skirt panel by
removing screws from skirt. Then carefully place the
spa on the dolly so only the reinforced area contacts
4" X 4" X 72"
BLOCK
REMOVE
BOLTS
BRACKETS
PAN
SKIRT
PALLET
C.
SKIRT REMOVED
(FOR MOVING SPA
WITHOUT A PALLET)
REINFORCED AREA
(FOR MOVING SPA
WITHOUT A PALLET
B.
A.