Jacuzzi J - LX Hot Tub User Manual


 
19
LX Collection
14. Turn on all jet pumps when adding chemicals to ensure proper
mixing and leave your spa cover open until the sanitizer level falls
below 4.0 ppm to protect pillows and plastic knobs from chemical
attack.
WARNING: RISK OF PERSONAL INJURY.
To decrease the risk of injury, entrapment or drowning,
never leave your hot tub unattended for any reason, es-
pecially if while the cover is open and accessible to small
children and animals!
To decrease the risk of contracting a waterborne
illness
(e.g. an infection, bacteria or virus) and/or respiratory ail-
ments, maintain water chemistry within 6 step parameters.
If you or other bathers experience such a condition, discon-
tinue use and seek immediate medical attention.
!
15. Establish a sanitizer reading between 3.0-4.0 ppm chlorine or
2.0-4.0 ppm bromine, then allow the spa to set undisturbed for 8
hours. Retest water after 8 hours to determine if sanitizer levels
are stable. If sanitizer levels are stable, your spa is ready for use.
To ensure healthy water conditions, always maintain a constant
sanitizer reading within the levels recommended by the Association
of Pool and Spa Professionals/USA printed on the inside cover of
this manual. If sanitizer levels are not stable at this time, it will be
necessary to repeat this procedure in its entirety (steps 1-15) until
stable sanitizer readings are achieved.
16. After adequate sanitizer levels are achieved, close all spa air controls
to maximize heat retention when spa is not in use.