Filter
Top Products
Page 15
J-400 Series
Export J-460/J-465/J-470/J-480 Models (50Hz)
Voltage: 230 VAC 230 VAC 230 VAC
Max. Current Draw: 16A 21A 29A
Frequency: 50 Hz 50 Hz 50 Hz
Number of Wires: 3 3 3
Circuit Breaker (2-Pole): 20A* 30A** 40A***
*
In 20A conguration, the heater will not operate while either jets
pump is running.
**
In 30A conguration, the heater will not operate while both jets
pumps are running. This is the factory setting.
***
In 40A conguration the heater will operate while both jets pumps
are running.
8.0 Spa Fill Up Procedure
PROCEEDING WITH THIS PROCEDURE.
1. Prepare The Spa For Filling
• Clear all debris from the spa. (Although the spa shell has been
polished at the factory, you may want to treat it with a specially
formulated spa cleaner. Consult your authorized Jacuzzi dealer for
additional information prior to lling spa.
• Remove both ProClear™ Plus skimmer and polishing lter lids and
lters as illustrated in section 13.1 (page 43).
2. Fill Spa
• Place the end of your garden hose into empty skimming lter bucket
(lter bucket on your left) as you stand next to the spa. Fill spa half
way, then place the garden hose into the opposite lter bucket (lter
bucket on your right) while adding the remaining ll water.
CAUTION: TO DECREASE BUILD UP ON COMPONENTS AND
MINIMIZE ACRYLIC DAMAGE.
Never ll with water from a water softener. If your water is
extremely “hard”, it is preferable to ll half-way with hard water and
the rest of the way with softened water. You may ll entirely with
hard water if you use a special water additive available from your
Jacuzzi dealer.