Filter
Top Products
9-12 333559 09/08
The Hustler FasTrak is equipped with two Hydro-Gear EZT integrated pump/motor transmissions (FIG. 5).
The EZT integrated pump/motor transmission are sealed for life and do not require any scheduled service.
The EZT integrated pump/motor transmissions are filled with 20W50 engine oil. If they ever become low on
oil, fill to the level shown in FIG. 6.
Fuel system
DANGER: Observe usual fuel handling precautions:
Do not smoke while refueling. Extinguish all cigarettes, cigars, pipes and other sources of ignition.
Do not remove fuel cap or fill tank with engine running or while engine is hot. Clean up any gasoline
spills.
Allow engine to cool before storing machine inside a building.
Keep fuel away from open flame or spark and store machine away from open flame or spark or pilot light
such as on a water heater or other appliances.
Use extreme care when handling gasoline and other fuels. They are extremely flammable and vapors
are explosive. A fire or from gasoline can burn you and others and can damage property.
Never refuel or drain the fuel from the machine indoors.
Never attempt to start engine when there is a strong odor of gasoline fumes present. Locate and correct
cause.
Store gasoline in an approved container and keep it out of the reach of children. Never buy more than a
30 day supply of gasoline.
Always place gasoline containers on the ground away from your vehicle before filling.
Do not fill gasoline containers inside a vehicle or on a truck or trailer bed with interior carpets or plastic
bed liners.
Always place gasoline containers on the ground away from your vehicle before filling.
When practical, remove gas-powered equipment from the truck or trailer and refuel the equipment with
its wheels on the ground. If this is not possible, then refuel the equipment on the truck or trailer using a
portable container an not a gasoline dispenser nozzle. If a gasoline dispenser nozzle must be used,
keep the nozzle in contact with the rim of the fuel tank or container opening at all times until fueling is
complete. Do not use a nozzle lock-open device.
FIG. 5
FIG. 6
EZT INTEGRATED
PUMP/MOTOR