Hustler Turf 928168 Lawn Mower User Manual


 
108604 10/08 12-11
The battery is located under the seat platform "FIG. 4".
WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds,
chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after
handling.
WARNING: Avoid skin and clothing contact with battery acid.
Always wear eye protection when checking the battery, acid can cause serious injury to skin and eyes.
If contact occurs, flush area with clean water and call physician immediately. Acid will also damage
clothing.
Do not drink the battery electrolyte.
Do not allow open flame near the battery when charging.
Hydrogen gas forms inside the battery. This gas is both toxic and flammable and may cause an
explosion if exposed to flame.
Always remove the negative ground first and replace it last.
Do not overfill battery.
Electrolyte may overflow and damage paint, wiring or structure. When cleaning the battery, use soap
and water. Be careful not to get soap and water into the battery. Clean the battery terminals with a
solution of four parts water and one part baking soda when they become corroded.
WARNING: Shorts caused by battery terminals or metal tools touching metal tractor components can
cause sparks. Sparks can cause a battery gas explosion which will result in personal injury.
Prevent the battery terminals from touching any metal tractor parts when removing or installing the
battery.
Do not allow metal tools to short between the battery terminals and metal tractor parts.
WARNING: Incorrect battery cable routing could cause damage to the tractor and battery cables. This
can cause sparks which can cause a battery gas explosion which will result in personal injury.
Always disconnect the negative (black) battery cable before disconnecting the positive (red) cable.
Always connect the positive (red) battery cable before connecting the negative (black) cable.
Common circuit failures are usually caused by shorting, corroded or dirty terminals; loose connections,
defective wire insulation or broken wires. Switches, solenoids and ignition components may also fail,
causing a shorted or open circuit.
FIG. 4
BATTERY