Hustler Turf 928168 Lawn Mower User Manual


 
12-28 108604 10/08
3. Raise deck and place 3.25” block under the back of the deck and a 4” block under the
front of the deck "FIG. 33". This will set the cutting height at 3-1/2 ".
NOTE: Back of deck will automatically be set approximately ¼" higher.
4. Set cutting height at 3-1/2" in the height indicator by placing the height adjusting stop
in the 3-1/2" hole, and turning the height stop so that the pin side is against the stop
handle "FIG. 34"
5. Clamp the height adjusting stop against the stop handle "FIG. 34". This will assure
that the height will not move during the setting process. Otherwise, spring pressure
from the deck lift springs will tend to pull the stop away from the handle.
6. Loosen all nuts on the deck lift threaded rods, and the hardware on the adjuster (on
the right front), until all the deck lift chains are loose, and the deck is sitting tightly on
all four blocks "FIG. 35", "FIG. 36", "FIG. 37".
FIG. 34
FIG. 35 FIG. 36
STOP HANDLE
HEIGHT
ADJUSTING
STOP
CHAINS
NUT
NUT
DECK LIFT
THREADED ROD
DECK LIFT
THREADED ROD
NUT
NUT
CHAINS