Filter
Top Products
601396_0109 7-1
STORAGE
When storing the unit at the the end of the mowing season, the
following steps should be taken to ensure readiness for the next
mowing season.
1. Remove all grass, dirt, and trash from tractor and mower.
Clean tractor and mower and touch up all scrapes with
Hustler spray paint.
IMPORTANT: Wash the machine with a mild detergent
and water. Do not pressure wash the machine. Avoid
excessive use of water, especially near the control panel,
engine and the integrated pump/motor units.
2. Install new air filter per Engine Owner’s Manual.
3. Check thoroughly for any worn or damaged parts that
need replacing and order them from your dealer.
4. Thoroughly lubricate machine, according to lubrication
instructions.
5. Block tractor up so weight is off tires.
6. Do not deflate tires.
7. Remove the battery from machine
a. Clean battery
b. Check the electrolyte level
c. Charge the battery, if necessary
d. Store battery in a cool, dry place (do not expose to
freezing temperatures)
e. Always keep the battery fully charged. (Especially
important to prevent battery damage when the
temperature is below 32°F.)
8. Perform separate engine preparation as listed below.
9. Store tractor in a clean, dry place.
Preparation of engine for storage
When engine is to be unused for long periods, proceed as
follows:
1. Run engine for a minimum of 15 minutes.
2. Drain oil from crankcase while engine is still warm.
3. Refill with fresh oil of proper viscosity.
4. Drain fuel tank and run the engine until it stops from lack
of fuel. Gasoline evaporates if left in carburetor for long
periods, forming gum and varnish deposits in carburetor.
These deposits will cause engine flooding and loss of
power.
5. Remove and replace fuel filter if not done in previous
100 hours.
6. Remove spark plugs and pour a tablespoon of engine oil
into each spark plug hole, Install plugs, but do not
reconnect plug leads.
7. Crank engine with starter at least a dozen revolutions to
distribute oil over cylinder walls and valve mechanism.
8. Clean exterior surface of engine. Spread a light film of
oil over any exposed metal surfaces of engine that are
subject to corrosion.
9. Clean dirt and chaff from cylinders and fins, blower
housing and muffler.
10. Check oil filler cap and fuel tank cap to make certain they
are securely in place.
11. Refer to engine manual for more information.
New season preparation
Before starting the tractor following post season storage, the
following servicing is required:
1. Clean tractor, removing trash and dirt accumulation.
2. Check engine oil level.
3. Fill fuel tank with fresh gasoline. Run machine at half
speed for 5 minutes, checking operation of steering
control lever. Stop engine and check for oil leaks, loose
fittings and so forth.
4. Tighten any bolts that have loosened and make sure all
hair pins, cotter pins and clevis pins are in place.
5. Install all safety shields and review safety precautions
listed in this manual.
6. Check and inflate tires to 8-12 psi.
7. Refer to engine manual for more information.
PRODUCT LITERATURE
This section contains sources of additional literature
concerning your tractor. Literature should be ordered from your
Hustler dealer or direct from indicated source.
Parts Manuals
If you would like to order a Parts Manual for a particular
tractor, the Hustler part number for that manual is listed in the
following chart. Please contact your Hustler dealer to order the
manual.
Model Model Number Parts Manual P/N List Price
Hustler Sport 929125, 929133 110907 $22.50