Filter
Top Products
MAINTENANCE
English – 35
Chain catcher
• Check that the chain catcher is not damaged and is
firmly attached to the body of the chain saw.
Keypad
• Activate the chain saw (green LED on) and make sure
the chain saw deactivates when the start/stop button
is pressed (green LED off).
Lubricating the bar tip sprocket
• Lubricate the bar tip sprocket each time you refill with
saw chain oil. Use the special grease gun and a good
quality bearing grease.
Battery connectors
Clean the battery and the machines battery compartment
with a soft brush after use. Make sure all cooling slots and
battery connectors are cleaned.
Cooling system
To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake (left side of the machine).
2 A fan on the motor.
• Clean the cooling system with a brush once a week,
more often in demanding conditions. A dirty or
blocked cooling system results in overheating which
causes damage to the machine.
Li-ion
Li-ion
Li-ion
Li-ion
Li-ion
Li-ion
Li-ion
Li-ion