Filter
Top Products
BATTERY HANDLING
22 – English
Transport and storage
• The contained lithium-ion-batteries are subject to the
Dangerous Goods Legislation requirements.
• For commercial transports e.g. by third parties,
forwarding agents, special requirement on packing
and labeling must be observed.
• For preparation of the item being shipped, consulting
an expert for hazardous material is required. Please
also observe possibly more detailed national
regulations.
• Tape or mask off open contacts and pack up the
batteriy in such a manner that it cannot move around
in the packing.
• Always remove the battery for storage or transport.
• Store the battery and the battery charger in a dry,
moisture-free and frost-free space.
• Do not store the battery in places where static
electricity can occur. Never store the battery in a metal
box.
• Store the battery and the battery charger where the
temperature is between 5
°C and 45 °C and never in
direct sunlight.
• Store the battery charger only in an enclosed and dry
space.
• Be sure to store the battery separate from the battery
charger. Store the equipment in a lockable area so
that it is out of reach of children and unauthorized
persons.
• Ensure the machine is cleaned and that a complete
service is carried out before long-term storage.
• The guide bar cover must always be fitted to the
cutting attachment when the machine is being
transported or in storage, in order to prevent accident
contact with the sharp chain. Even a non-moving
chain can cause serious cuts to yourself or persons
you bump into with an exposed chain.
• Secure the machine during transport.
Disposal of the battery, battery
charger and machine
Symbols on the product or its packaging indicate that this
product cannot be handled as domestic waste. It must
instead be submitted to an appropriate recycling station
for the recovery of electrical and electronic equipment.
By ensuring that this product is taken care of correctly, you
can help to counteract the potential negative impact on
the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
LED display Charging status
LED 1 flashes
The battery is 0%-
25% charged.
LED 1 is lit, LED 2 flashes.
The battery is 25%-
50% charged.
LED 1, LED 2 are lit, LED 3 flashes
The battery is 50%-
75% charged.
LED 1, LED 2, LED 3 are lit, LED 4
flashes
Battery is 75%-
100% charged
LED 1, LED 2, LED 3, LED 4 are lit.
When all the LEDs
are lit on the battery,
it is fully charged.
Li-ion