Filter
Top Products
English – 7
INSTALLATION
There is a momentary switch on the charging station for testing.
A continuous beep when the switch is switched on indicates
that the charging station is receiving power and that the search
and boundary wires are connected. A series of beeps indicates
that the charging station is receiving power, but the search or
boundary wires or both are disconnected or broken.
How far inside the outer edge of the working area the boundary
wire should be placed depends on what lies immediately outside
the area. If there is a high obstacle, such as a wall or fence, or
delicate flowers, just outside the area to be mown, the boundary
wire should be laid 40 cm from the obstacle. This should prevent
the Auto Mower bumping into it.
40 cm
30 cm
~15
cm
~15
cm
Boundary wire
When the Auto Mower reaches the boundary wire it senses that
it is passing the wire. It then continues for a short distance
beyond the wire before reversing.
Where a path has been laid at the same level as the lawn, it is
possible to allow the Auto Mower to drive a little way on to the
path and cut the grass right up to the edge. In this case, lay the
boundary wire about 10 cm from the edge of the path.
10 cm
≥
2
m
Long narrow passages (more than 2 meters in length) should
be at least 2 m wide, i.e. leaving 140 cm between the wires, to
give the Auto Mower enough space to make its way through.
See the illustration. Shorter passages (less than 1 meter long)
should be at least 1.2 m wide.
40x40
cm
40x40
cm
Installation of boundary wire
The boundary wire must be laid along the outer edge of the
Auto Mower’s working area.
Where the lawn finishes with a ditch or a small rise, such as
curb stones (max. 5 cm high), lay the boundary wire 30 cm
inside the edge of the working area. This ensures that the
wheels will not fall into the ditch or ride up on the curb stones.
If the lawn slopes down toward the boundary wire this distance
must be increased by 5–10 cm because of the slope.
There should be two free zones of 40 cm on both short sides of
the charging station to provide optimal operation. Accordingly,
the boundary wires should run from the charging station in line
with its outer edges.
The nose of the mower projects no more than 30-35 cm over
the boundary wire and the front wheel projects 10-15 cm over
the boundary wire. The Auto Mower mows around 12-17 cm
over the boundary wire.