Husqvarna LZ7230, LZ6127 Lawn Mower User Manual


 
English-46
MAINTENANCE
Pump belt
Check belt every 100 hours for excessive wear.
To replace belt. Relieve tension on the deck belt and
remove deck belt from clutch. See “Deck belt” section.
Loosen bolt on the clutch tie down and rotate out of
the way.
Using a ½" drive ratchet inserted into the square hole
in the pump idler arm, relieve the tension on the pump
belt and remove belt.
To reinstall the belt, swing pump idler pulley toward
engine to route belt around it. Then route belt around
the pulley for left pump rst (right hand pulley in the
illustration).
Reinstall idler spring and use the ratchet to rotate idler
so the belt may be installed all the way around the last
pulley.
8011-623
Slackening the belt tension
8011-624
Belt routing, hydraulic pumps
Checking Tire Pressures
All four tires should have a pressure of 15 psi / 103
kPa /1 bar.
WARNING!
Faulty adjustment of the parking
brake can cause an accident.
8011-511-1
Released parking brake
Checking the Parking Brake
Visually check that no damage is found on the lever,
links, or switch belonging to the parking brake.
Perform a test drive and check that there is suf cient
braking action.
To adjust the parking brake, contact the Husqvarna
service workshop.