Filter
Top Products
English-43
MAINTENANCE
IMPORTANT INFORMATION
The end cover must be installed with the
rubber valve pointing downwards or the
rubber valve will not function.
Pull the main fi lter (outer) fi lter out.1.
Remove the inner fi lter.2.
Clean inside the fi lter housing, cover 3.
housing and dust cap. Wipe dry only.
Reinstall or replace the inner fi lter with the 4.
open end fi rst, ensuring that it enters the
housing recess. Push in to the end.
Reinstall or replace the outer fi lter with the 5.
open end fi rst so that it enters the recess.
Push in to the end.
Replace the end cover with the rubber valve 6.
pointing downwards and secure retaining
clips.
8011-449
Removing the main fi lter
8011-450
Removing the inner fi lter
Engine Oil Cooler
Clean the outside of fi ns with a brush.
Remove the two screws holding the cooler unit to the
blower housing.
Tilt the cooler downward.
Clean the inside of the cooler with a brush or with
compressed air.
Reinstall the oil cooler to the blower housing
8011-472
Engine oil cooler