Husqvarna HUV 4214 Utility Vehicle User Manual


 
Engine Oil
26
Figure 18 Remove Engine Oil Filter
27
Figure 19 Coat Rubber Seal
4. Use a clean, lint-free rag to wipe the oil lter port ange surface clean where the oil lter gasket seats.
5. To help seal the new oil lter to the oil port ange, apply a light coat of white lithium NLGI Number 2 grease
(Dow Corning
®
BR2-Plus or equivalent) or new engine oil to the rubber seal around the outside surface of the
lter before attaching it to the oil lter port (Figure 19). Install the new oil lter onto the engine oil lter port.
See following NOTE.
NOTE: Use only engine-compatible oil lters designed for your engine.
6. Tighten the oil lter by hand 2/3 turn after gasket contact. Do not use a band wrench or channel lock pliers.
806
Figure 20 Add Engine Oil
Page 38 2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual