Husqvarna HUV 4214 Utility Vehicle User Manual


 
Engine Oil
1
2
815
Figure 17 Engine Oil Drain Plug and Oil Filter Wrench
Engine Oil Filter Change
1. Drain the engine oil. See Engine Oil Draining on page 36.
2. Place the oil drain pan under the engine oil lter (Figure 18).
3. Remove the engine oil lter. Turn it counterclockwise and drain the residual oil in the lter port and lter into
the oil drain pan. See following NOTE.
NOTE: We recommend using an oil lter wrench of the type shown (2) (Figure 17) (Ampro
®
P/N T70413785A255 or
equivalent). An oil drip guard can be used to prevent excess oil from dripping onto the engine base plate
(Figure 18). Use an empty quart (one liter) container and cut the bottom off at an angle, then slide the open
area of the container up and under the oil lter before removal. Position the port of the plastic container so
oil will be directed into the oil pan. A drip guard can be made by folding a piece of cardboard, thin metal, or
plastic under the oil lter, forming a channel to direct the lter port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 37