Husqvarna HUV 4213-G Utility Vehicle User Manual


 
Model Identication
WARNING
Follow the procedures exactly as stated in this manual, and heed all DANGER, WARNING, and
CAUTION statements in this manual as well as those on the vehicle.
Do not leave children unattended on vehicle.
Prior to leaving the vehicle unattended or servicing the vehicle, set the park brake, place the
Forward/Reverse handle in the NEUTRAL position, turn the key switch to the OFF position, and remove
the key. Chock the wheels when servicing the vehicle.
Improper use of the vehicle or failure to properly maintain it could result in decreased vehicle
performance, severe personal injury, or death.
Any modication or change to the vehicle that affects the stability or handling of the vehicle, or
increases maximum vehicle speed beyond factory specications, could result in severe personal
injury or death.
Check the vehicle for proper location of all vehicle safety and operation decals and make sure they are
in place and are easy to read.
For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If the
vehicle is equipped with a prop rod, ensure that it is securely engaged while bed is raised. Do not
close bed until all persons are clear of cargo bed area. Keep hands clear of all crush areas. Do not
drop cargo bed; lower gently and keep entire body clear. Failure to heed this warning could result in
severe personal injury or death.
Only trained technicians should service or repair the vehicle. Anyone doing even simple repairs or
service should have knowledge and experience in electrical and mechanical repair. The appropriate
instructions must be used when performing maintenance, service, or accessory installation.
To avoid unintentionally starting the vehicle:
Disconnect battery cables, negative (–) cable rst (Figure 2).
Disconnect the spark plug wire from the spark plug.
Frame ground – Do not allow tools or other metal objects to contact frame when disconnecting battery
cables or other electrical wiring. Do not allow a positive wire to touch the vehicle frame, engine, or
any other metal component.
Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
Do not wear loose clothing or jewelry such as rings, watches, chains, etc., when servicing the vehicle.
Use insulated tools when working near batteries or electrical connections. Use extreme caution to
avoid shorting of components or wiring.
MODEL IDENTIFICATION
The serial number of each HUV4213 vehicle is printed on a bar code decal mounted on the frame directly above the
accelerator pedal (Example: SH0501-583947) (Figure 3). There is also a second serial number decal mounted on
the front body frame behind the instrument panel. The instrument panel must be removed to view this decal. See
following NOTE.
NOTE: Have the vehicle serial number available when ordering parts or making inquiries.
Page 10 2008 HUV 4213-G and HUV 4213-GXP Owner’s Manual