Filter
Top Products
Cleaning the Vehicle
Page 48 2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual
3. The fuel tank is located on passenger side of vehicle. Remove fuel cap and fill the fuel tank with fresh
unleaded gasoline only. See preceding CAUTION.
4. Replace fuel cap on tank. Ensure cap is tightened securely.
5. Replace seat bottom.
CLEANING THE VEHICLE
Husqvarna vehicles are equipped with ABS front bodies and TPO for rear bodies. Use only commercially
available automotive cleaners with a sponge or soft cloth for normal cleaning. A garden hose at normal resi-
dential water pressure is adequate.
Husqvarna does not recommend any type of pressure washing or steam cleaning. Such a process (especially
if the vehicle has the rear body removed) will expose electrical components to moisture. Moisture entering
electrical components can result in water damage and subsequent component failure.
Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should
be removed immediately to prevent possible stains.
The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm
water applied with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult
stains or scratches, blemishes, or other body damage, see Section 4 of the appropriate maintenance and ser-
vice manual.
NOTE: Dispose of waste water properly.
Figure 32 Fuel Tank
1. Vent 2. Fuel Shut-off Valve 3. Vent Tube
1
3
2