Husqvarna HUV4210-E Utility Vehicle User Manual


 
Periodic Service Schedules
2008 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 33
PERIODIC SERVICE SCHEDULE – ELECTRIC VEHICLES
REGULAR INTERVAL SERVICE
Daily service by owner
Pre-Operation and Daily Safety Checklist
See Pre-Operation and Daily Safety
Checklist on page 20.
Performance Inspection See Performance Inspection on page 21.
Batteries Charge batteries (after each daily use only).
Weekly service by owner Batteries
Check electrolyte level. Add water if
necessary. See page 37.
Monthly service by owner
or trained technician
Batteries
Wash battery tops and clean terminals
with baking soda/water solution.
Tires
Check air pressure and adjust if
necessary. See Vehicle Specifications
on page 50.
General vehicle
Wash battery compartment and underside
of vehicle.
Semiannual service by trained
technician only (or every 50 hours of
operation, whichever comes first)
Brake system
Check brake shoes; replace if necessary.
See Section 6 – Wheel Brake
Assemblies in the appropriate
maintenance and service manual.
Lubricate brake slides per Lubrication
Schedule. See Section 6 – Wheel Brake
Assemblies in the appropriate
maintenance and service manual.
Check brake cables for damage; replace if
necessary.
Electrical wiring and connections Check for tightness and damage.
Forward/Reverse switch
Check condition of contacts and wire
connections. Make sure connections are
tight.
Front wheel alignment and camber
Check and adjust as required. See
Section 7 – Steering and Front
Suspension in the appropriate
maintenance and service manual.
Annual service by trained technician
only (or every 100 hours of operation,
whichever comes first)
Motor controller output regulator (MCOR)
Check for loose hardware, cracks and
other damage.
Batteries
If batteries are not performing as
expected, see Section 13 – Batteries in
the appropriate maintenance and service
supplement.