Husqvarna GTH220 Lawn Mower User Manual


 
SERVICE AND ADJUSTMENTS
23
TO ADJUST BRAKE (See Fig. 27)
Your tractor is equipped with an adjustable brake system
which is mounted on the side of the transaxle.
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
Depress clutch/brake pedal and engage parking brake.
Measure distance between brake operating arm and
nut “A” on brake rod.
If distance is other than 1-1/2", loosen jam nut and turn
nut “A” until distance becomes 1-1/2". Retighten jam
nut against nut “A”.
Road test tractor for proper stopping distance as stated
above. Readjust if necessary. If stopping distance is
still greater than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au-
thorized service center/department.
1-1/2"
OPERATING
ARM
WITH PARKING BRAKE “ENGAGED”
NUT “A”
JAM NUT
FIG. 27
TO REPLACE MOTION DRIVE BELT
(See Fig. 28)
Park the tractor on level surface. Engage parking brake.
For ease of service there is a belt installation guide decal on
bottom of left footrest.
Remove mower (See “TO REMOVE MOWER” in this
section of this manual.)
BELT REMOVAL -
Engage parking brake (creates slack in belt).
Remove belt from clutching and fan idler pulleys.
Remove belt from transaxle pulley.
Remove belt from engine pulley and front V-idler pul-
ley.
Pull belt out of all belt keepers and remove from tractor.
BELT INSTALLATION -
Place V part of belt into grooves on engine pulley and
front V-idler, making sure to route belt inside of all belt
keepers.
Route belt on right side, coming from V-idler, towards
back of tractor, above midspan belt keeper and to top
of transaxle pulley.
Route belt on left side, coming from engine pulley,
towards back of tractor and through loop in midspan
belt keeper.
Place V part of belt into grooves on transaxle and fan
idler pulleys, making sure to route belt inside of all belt
keepers.
Place belt around clutching idlers as shown, making
sure to route belt inside of all belt keepers.
Check to be sure belt is positioned correctly and is on
proper side of all belt keepers.
Reinstall mower.
IMPORTANT: CHECK BRAKE ADJUSTMENT.
TRACTOR V-BELT DRIVE SCHEMATIC
VIEWED FROM L.H. SIDE OF TRACTOR
V-IDLER
ENGINE
PULLEY
BELT
TWISTS
BELT
KEEPER
BELT
KEEPER
V-IDLER
AS VIEWED FROM BOTTOM
ABOVE BELT
KEEPER
TRANSAXLE
PULLEY
CLUTCHING
FLAT IDLER
CLUTCHING
IDLER
BELT
KEEPER
ENGINE
PULLEY
FAN
IDLER
FIG. 28