Filter
Top Products
English-42
MAINTENANCE
Nose Roller
Nose rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Nose
rollers keep the deck in the proper position to help
prevent scalping in most terrain conditions.
Adjust the deck to the desired cutting •
height (see “TO ADJUST DECK CUTTING
HEIGHT” in the operation section of this
manual).
Using a •
9
/16" wrench, remove the nut and
shoulder bolt from the nose roller.
Lower the roller to the ground, and raise it •
up to the next highest hole.
Replace and tighten the nut and shoulder •
bolt.
Be sure to readjust the nose roller if the cutting height
is changed.
1. Bolt
2. Nut
Nose roller
3. Turn both outer blades to align with the deck in
front-to-rear manner. Reposition rear mounting
bolts up or down until rear of mower deck is
positioned level to
1
/8" higher in the rear than
the side-to-side measurement.
4. Conrm measurements once again. Blade tips
should be level in a side-to-side manner. In the
rear, blade tips should be level to
1
/8" higher
than side-to-side measurement. In the front,
blade tips should be level to
1
/8" lower than
side-to-side measurement.
NOTE: This will place the mower deck in
a base measurement position. Ad-
ditional adjustment may be required
to achieve desired cut for the type of
grass or conditions being mowed.
1
2