Filter
Top Products
English-29
OPERATION
Moving by Hand
When pushing or pulling unit, the hydraulic pump
dump valves must be opened
• Always turn off engine before engaging or
disengaging the hydro release.
• The hydro release valves are located below
the seat, on the front side of the hydro
pumps.
• Raise the deck into the highest cutting
position.
• Lift the seat frame assembly to access the
release valves.
• Use a
5
/8" wrench to rotate bolt counter-
clockwise two full turns to disengage pump.
• Repeat the procedure for the opposite pump.
• To engage, rotate each pump bolt clockwise
until the bolt is snug. Do not overtighten the
release valve or damage to the hydro pump
could occur.
WARNING!
Make no adjustments without:
the engine stopped•
the ignition key removed•
the parking brake activated•
1. Left hydro pump
2. Release valve
Bypass linkages
8050-767
1
2
IMPORTANT INFORMATION
Before pushing or towing tractor,
transmission dump valves must be
opened and park brake released. The
tractor should never be pulled at more
than 2 miles per hour (3.2 km/h) or for
distances over ¼ mile (.402 km). Trailer
the unit for distances over ¼ mile.