Filter
Top Products
English-30
OPERATION
To attach jumper cables
• Connect each end of the RED cable to
the POSITIVE (+) terminal on each
battery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of the fully
charged battery.
• Connect the other end of the BLACK
cable to a good CHASSIS GROUND on
the mower with the discharged battery,
away from the fuel tank and battery.
To remove cables, reverse order
• Remove BLACK cable first from chassis
and then from the fully charged battery.
• Remove RED cable last from both
batteries.
Running
1. Release the parking brake by moving the
lever forward.
Your mower is equipped with an operator
presence system. When the engine is
running, any attempt by the operator to
leave the seat without first setting the
park brake will shut off the engine.
2. Move the steering controls to the neutral
position (N).
3. Select the cutting height by placing the
peg in one of the holes. Lock the peg on
the inside with the pin.
4. Press in the stop handle, counter hold,
and carefully move the lifting lever
forward from the transport position
toward the peg.
BAM-4
Released parking brake
CUTTING HEIGHT
Cutting height selection
IMPORTANT INFORMATION
The mower deck’s anti-scalp rollers should
be evenly adjusted. See Maintenance
section.