Filter
Top Products
4
4
5
GENERAL IDENTIFICATION
8
9
7
13
21
14
17
18
12
16
15
SAFETY FEATURES
3 cutting attachment guard must be installed to prevent debris from being thrown at the operator and prevent the string
from extending longer than necessary.
17 MUFFLER SHIELD helps prevent hands, body and/or combustible materials from making contact with a hot muffler.
1. CUTTING HEAD
2. FLEXIBLE LINE
3. CUTTING ATTACHMENT
GUARD
4. BLADE
5. OUTPUT SHAFT
6. “LOOP WITH BARRIER”HANDLE
(BC 435L)
7.“BULLHORN” HANDLE
(BC 435B)
8. THROTTLE TRIGGER
9. ON/OFF SWITCH
10. THROTTLE TRIGGER LOCK
OUT
11. THROTTLE LOCK
12. CHOKE LEVER
13. STARTER ROPE HOUSING
14. FUEL TANK
15. AIR FILTER COVER
16. STARTER HANDLE
17. MUFFLER SHIELD
18. PRIMER BULB
19. HARNESS
20. COUPER
21. OIL TANK
(
BC 435B
/ BC 435L )
3
6
8
9
10
10
11
20
19
3
1. FOLLOW ALL WARNINGS and instructions regard-
ing operation and blade installation.
2. BLADE CAN VIOLENTLY THRUST AWAY FROM
MATERIAL IT CANNOT CUT - Blade thrust can
cause amputation of arms or legs. Keep people
and animals 50 feet (15 meters) away in all directions.
If blade contacts foreign objects during operation,
turn off engine and allow coasting blade to stop.Then
check blade for damage. Always discard blade if it is
warped or cracked.
3. BLADE THROWS OBJECTS VIOLENTLY - You can
be blinded or injured.Wear eye, face, and leg protec-
tion. Always clear work area of any foreign objects
before using blade. Keep people and animals 50 feet
(15 meters) away in all directions.
4. INSPECT YOUR TRIMMER AND ATTACHMENTS
BEFORE EACH USE - Never use unless all blade-
attaching hardware is properly installed.
5. BLADE COASTS AFTER THROTTLE IS RELEASED
- A coasting blade can cut you or bystanders. Before
per
forming any service on the blade, always turn off
engine, and be sure coasting blade has stopped.
6. 50 FEE T (15 meters) DIAMETER HAZARD ZONE -
Bystanders can be blinded or injured. Keep people
and animals 50 feet (15 meters) away in all directions.
1. DO NOT USE ANY OTHER FUEL than that recom-
mended in your manual. Always follow instructions in
the Fuel and Engine oil section of this manual.
Permanent damage to engine will result,
voiding manufacturer’s warranty.
2. DO NOT SMOKE while refueling or operating equip-
ment.
3. DO NOT OPERATE UNIT WITHOUT A MUFFLER
and properly installed muffler shield.
4. DO NOT TOUCH or let your hands or body come in
contact with a hot muffler or spark plug wire.
5. DO NOT OPERATE UNIT IN AWKWARD POSI-
TIONS, off balance, outstretched arms, or one-hand-
ed. Always use two hands when operating unit with
thumbs and fingers encircling the handles.
6. DO NOT RAISE CUTTING HEAD ab
ove ground level
while unit is operating. Injury to operator could result.
7. DO NOT USE UNIT FOR ANY PURPOSES OTHER
than trimming lawn or garden areas.
8. DO NOT OPERATE UNIT FOR PROLONGED PERI-
ODS. Rest periodically.
9. DO NOT OPERATE UNIT WHILE UNDER THE
INFLUENCE OF ALCOHOL OR DRUGS.
10. DO NOT OPERATE UNIT UNLESS CUTTING
ATTACHMENT GUARD AND/OR GUARD IS
INSTALLED AND IN GOOD CONDITION.
11. DO NOT ADD, REMOVE OR ALTER ANY COMPO-
NENTS OF THIS PRODUCT. Doing so could cause
personal injury and/or damage the unit voiding the
manufacturer’s warranty.
12. DO NOT operate your unit near or around flammable
liquids or gases whether in or out of doors. An explo-
sion and/or fire may result.
13. DO NOT USE ANY OTHER C
UTTING A
TTACHMENT.
Use only Partner replacement parts and acces-
sories, which are designed specifically to enhance the
performance and maximize the safe operation of our
products. Failure to do so may cause poor perform-
ance and possible injury. Use only the cutting head
supplied with this product. Do not use any other cut-
ting attachment. Use of such attachments will void
your factory warranty and could result in serious bod-
ily injury.
WHAT NOT TO DO
BRUSH / GRASS BLADE SAFETY PRE-
CAUTIONS
2
1
BC 435L
BC 435B
GB GB