Filter
Top Products
44 – English
ASSEMBLY INSTRUCTIONS
Applies to model AR25.
1. Use eye protection. Remove the wooden blocks.
IMPORTANT INFORMATION
Be careful for nails and slivers.
2. Carefully cut along the side of the box.
3. The lawn aerator is delivered with the handle
removed. Fit the handle using two wrenches
(13 mm).
4. Slide the handle onto the mountings (see the
top illustration). Affix the handle on the
mountings using fittings A (see the bottom
illustration).
5. Fit the upper part of the control rod (3 on the top
illustration) to the rear wheel control (4 on the
top illustration) using fittings B (see the bottom
illustration).
6. Affix the lower part of the control rod to the
outer side of the torque arm mounting (1 on the
bottom illustration) using fittings C (see the
bottom illustration).
7. Connect the clutch cable by threading it
through the guide hole (6 on the top illustration)
at the back of the machine.
8. The lower end of the throttle cable (2) is factory-
installed. Insert it through the guide hole (8 in
the top illustration) and affix the spring for the
throttle/clutch (5 on the upper illustration).
9. Fill the engine with the manufacturer-
recommended oil. See the chapter ”Lubrication/
Engine oil”.
Fill the reduction gear with the manufacturer-
recommended oil. See the chapter ”Lubrication/
Oil change in reduction gear”. The machine
must be parked on level ground when inspecting
and filling oil.
10. Put the weights in the compartments on the
sides of the machine.
8011-075
8011-076