Filter
Top Products
26 – English
Cleaning the sludge reservoir
1. Close the fuel valve.
Idle adjustment
WARNING!
Risk for carbon monoxide
poisoning.
Perform the adjustment outdoors.
1. Start the engine and run it until it reaches
normal working temperature.
2. Adjust the throttle to idle position or so that the
engine runs at the lowest possible speed.
3. Turn the idle screw (1) so that the engine idles
at 1250-1400 RPM.
4. Increase the idle speed with the throttle and
move it right back to idle position. Check engine
speed again.
2. Unscrew the sludge reservoir (2). Make sure not
to misplace the o-ring (1).
3. Clean the reservoir and the o-ring in e.g. white
spirit and dry carefully.
4. Put the o-ring in place in its track and replace
the sludge reservoir. Tighten it moderately to
avoid damaging the threads.
5. Turn the fuel valve to ON and check for leaks. If
it leaks, replace the o-ring.
MAINTENANCE
8011-036
8011-047
8011-053