Filter
Top Products
English – 17
Fuel tank
Underneath the tank, there is a fuel filter combined
with the fuel valve. The tank volume is 2.5 liters/
0.66 US Gal.
Fueling
Read the safety instructions before fueling.
Keep the fuel and fuel tank clean. Avoid filling the
machine with dirty fuel. Make sure the fuel cap is
properly tightened and the gasket is not damaged,
particularly before washing the machine.
Use unleaded gasoline with minimum 86 octane
rating. Never use gasoline mixed with two-cycle oil.
For ethanol and methanol fuel, the following
applies:
Maximum allowable ethanol 10% (volume).
Maximum allowable methanol 5% (volume).
Maximum allowable MTBE (Methyl Tertiary Butyl
Ether) 15% (volume).
If the engine ”bolts” at normal load it can be
damaged. Change the fuel. If this does not help,
contact an authorized service workshop.
Do not fill the tank completely; leave space for the
fuel to expand as it warms up.
Reduction gear 1:6
The gear is directly coupled to the engine. A V-belt
pulley is located on the output axle with a key. The
gear reduces the speed of the engine so that the
output axle turns at 1/6 of the engine speed.
Oil refill reduction gear
The oil is filled through the plug (1) at the top of the
gearbox until it flows out of the hole for the removed
oil level plug (2). Use the same oil type as you used
in the engine. The gearbox can be filled with 0.15
liters/0.2 US qt.
Oil level reduction gear
The plug (2) is used to check the oil level in the
gearbox. When checking the level, the machine must
be parked on level ground. The plug can then be
removed and the oil should be level with the hole.
The hole is also used to drain the oil, but then the
machine must be tipped forwards.
WARNING!
Gasoline is highly flammable.
Observe caution and fill the tank
outdoors.
(See the safety instructions.)
8011-224
8011-055
PRESENTATION