Filter
Top Products
21
TOOLS REQUIRED:
2 each 3/4” wrenches
1 each 9/16” deep-well socket
1 each 9/16” wrench
PARTS INCLUDED:
Bolts: 1 each 3/8 x 1 hex w/nut
4 each 3/8 x 1 hex head w/nuts
3 each 1/2 x 3 hex head w/1 each 1/2" nut
Bushing: 5/8” x 9/16”
Washers: 2 each 1/2” SAE flat
10 each 3/8” SAE flat
1. Check to see that all bolts, washers, and nuts
are included in the plastic bag. Check for any
signs of damage that may have occurred during
shipment.
3. Install 1/2” X 3” bolt and washer through
frame mount and jack assembly. Add 1/2” lock
nut with washer and tighten.
4. Align jack lift assembly hole “C” with clear-
ance holes in frame and attach jack assembly
to bracket on axle using 3/8” X 1 1/2” bolt and
3/8” washers and lock nut.
2. Tip aerator onto its back edge and install jack
lift assembly. Install 5/8” X 9/16” bushing in hole
“C” near end of the jack assembly before
inserting into frame mount. Slide lift jack assem-
bly between the two frame mount brackets and
align frame mount hole “A” with lift assembly
hole “B”.
Operating Instructions for Model TA36