Filter
Top Products
SERVICE AND ADJUSTMENT
Recheck measurements after
adjustment.
MOWER
TO LEVEL DECK
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to the
correct pressure (see "SPECIFICATIONS"
section in this manual). If tires are under or over
inflated, you can not properly adjust your deck.
SIDE-TO-SIDE ADJUSTMENT (See Figs. 11
and 12)
Raise the deck into the highest cutting
position (4")
Measure height from the bottom edge of
the deck to the ground at both front
corners. Distance "A" should be the
same, or within 3/16 of an inch.
If adjustment is necessary, make
adjustment to one side of the deck only
Remove the hairpin from the top pin and
the bottom clevis pin. Push bottom clevis
pin through deck lift connector while
supporting deck. Adjust by moving the
deck lift connector to a new bottom hole
to lower or raise that specific corner of
the deck. You may need to flip the deck
connector plate to insure proper
clearance between deck connector plate
and yoke
23
FIGURE 11
FIGURE 12