Filter
Top Products
OPERATION
CAUTION
Attempting to zero turn at too high a ground
speed may result inTURF DAMAGE due to
the wheel spinning or slipage. The unit
should always be brought to a very slow
or stopped position prior to zero turning.
Use extra care when using this maneuver
the machine can spin very rapidly if one
lever is positioned too far ahead of the
other.
_i_ CAUTION
DO NOT apply excessive force to control
levers or use to assist in dismounting unit.
Misuse will result in bent control levers.
TO ADJUST THE DECK CUTTING
HEIGHT (See Fig. 5)
The deck cutting height is obtained by pressing
the foot pedal forward to lift the deck. To lower
the deck, you apply pressure to the top side of the
foot pedal and allow it to pivot while allowing the
lift arm to rotate to the rear of the mower. To stop
in a desired cutting position, rotate the foot pedal
down into the notch in the height plate. The
cutting height range is from 1 1/2" to 5" in 1/2"
increments. The heights are measured from the
ground up to the blade tip with the engine not
running.
The average lawn should be cut to 2 1/2"
during the cool season and to over 3"
during the hot months. For healthier and
better looking lawns, mow often and after
moderate growth.
For best cutting performance, grass over
6 inches in height should be mowed
twice. Make the first cut relatively high;
the second to the desired height.
FIGURE 5
FIGURE 4A
15