Filter
Top Products
42
MAINTENANCE
Tire Pressures
All tires should be at 15 psi / 103 kPa / 1 bar.
8011-564
Check tire pressures
Anti-scalp Rollers
Anti-scalp rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions.
Anti-scalp rollers can be set in four positions. The
rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
IMPORTANT INFORMATION
Adjust anti-scalp rollers with the mower on a
flat level surface.
8058-135
Anti-scalp rollers
IMPORTANT INFORMATION
To avoid deck damage, the anti-scalp rollers
must not be adjusted to support the deck.
Caster Wheels
Check every 200 hours. Check that wheels rotate
freely. If wheels do not rotate freely take the unit to
your dealer for service.
Foam filled tires or solid tires will void the warranty.
Removal and installation of caster wheel
1. Remove nut and caster bolt.
2. Pull the wheel out of the yoke and take care of the
spacers.
3. Install in reverse order. Tighten caster bolt.
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam fill
material to the tires. Excessive loads created by
foam filled tires will cause premature failures.
Only use O.E.M. specified tires.
8058-055
Caster wheels