Filter
Top Products
30
OPERATION
WARNING!
Engine exhaust and certain vehicle
components contain or emit chemicals
considered to cause cancer, birth defects
or other reproductive system damage.
The engine exhaust contains carbon
monoxide, which is a odorless, colorless,
poisonous gas. Do not use the machine
in enclosed spaces.
8058-253
Press S/S button to start
8. When the S/S button displays a rapid green blink,
press and release the button once more to start
the engine.
Allow the engine to run at a moderate speed,
approximately mid throttle, for a short time before
use.
IMPORTANT INFORMATION
Under normal starting conditions, use a press
and release method for the ignition start/stop
switch. Do not press and hold.
NOTE: For the first start after the unit has sat
idle for an extended period of time, or has been
refueled after being run out of gas, the engine
may require an extended start attempt to reprime
the fuel system. Press and hold down the S/S
switch for three seconds and then release. This
will prompt the engine starter to attempt starting
the engine for up to ten seconds (instead of the
normal five seconds), allowing time for fuel to be
pulled into the engine.
8058-248
Press the S/S button and enter the passcode
7. Press and release the S/S button to activate the
ignition switch. Check that the indicator is blinking
blue.
IMPORTANT INFORMATION
Either of two actions will wake up the ignition
switch—either the operator sitting on the seat
or pressing the S/S button.
Enter the passcode and press the S/S button.
The S/S button will flash one slow green blink if
the code is accepted and will change to a rapid
green blink.
If the S/S button has accepted the code but does
not stay lit with a rapid green blink, see Ignition
System Faults on the following page.