Filter
Top Products
8
STEP 19 - ASSEMBLE SUPPORT RODS
IMPORTANT: Do not
over bend the support rods during
the following step. Over bending will decrease the supporting
tension of the rods.
10.
Assemble the two hopper support rods as shown in
fi gure 20. Place the ends of the rods into the holes in
the upper and lower hopper tubes, fl exing the rod just
enough to fi t into the holes in the tubes.
STEP 18 - ATTACH BAG SIDES
9.
Fold the bag fl aps around the lower hopper tubes and
attach to the bag bottom using the snaps. See fi gure
19.
FIGURE 19
STEP 17 - ATTACH BAG BOTTOM
7.
Assemble the bag retainer and the bag frame strap to the
front edge of the bag bottom. Place the bag retainer on
top and the bag frame strap underneath the bag bottom.
Fasten together using six #10 x 5/8" screws and #10-32
nylock nuts. See fi gure
17.
FIGURE 18
FIGURE 20
CLEVIS PIN (N)
SMALL HAIR
COTTER PIN
BAG FRAME STRAP
SNAP
FLAP
SUPPORT
RODS
FIGURE 17
#10-32
NYLOCK NUT
FRAME STRAP
FRONT EDGE OF BAG BOTTOM
#10-32 x 5/8" SCREW
BAG RETAINER
8.
Assemble the bag frame strap to the holes in the lower
hopper tubes using two 1/4" x 1-1/8" clevis pins and
small hair cotter pins. See fi gure 18.