Husqvarna 326C, 326L, 326LS, 326LX-Series, 326LDX-Series Brush Cutter User Manual


 
22 – English
MAINTENANCE
Oiling the air lter
Always use HUSQVARNA lter oil, art. no. 531 00 92-48. The
lter oil contains a solvent to make it spread evenly through
the lter. You should therefore avoid skin contact.
Put the lter in a plastic bag and pour the lter oil over it.
Knead the plastic bag to distribute the oil. Squeeze the
excess oil out of the lter inside the plastic bag and pour off
the excess before tting the lter to the machine. Never use
common engine oil. This would drain through the lter quite
quickly and collect in the bottom.
Bevel gear
The bevel gear is lled with the right quantity of grease at the
factory. However, before using the machine you should check
that the bevel gear is lled three-quarters full with grease. Use
HUSQVARNA special grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.
CAUTION! Use only HUSQVARNA replacement parts. Use
of other brands of replacement parts can cause damage to
your unit or injury to the operator or others. Your warranty
does not cover damage or liability caused by the use of
accessories and/or attachments not specically
recommended by HUSQVARNA.