Husqvarna 326C, 326L, 326LS, 326LX-Series, 326LDX-Series Brush Cutter User Manual


 
14 – English
FUEL HANDLING
Mixing
Always mix the gasoline and oil in a clean container
intended for fuel.
Always start by lling half the amount of the gasoline to be
used. Then add the entire amount of oil. Mix (shake) the
fuel mixture. Add the remaining amount of gasoline.
Mix (shake) the fuel mixture thoroughly before lling the
machine’s fuel tank.
Do not mix more than one month’s supply of fuel at a time.
If the machine is not used for some time the fuel tank
should be emptied and cleaned.
Fueling
Clean the area around the fuel cap. Contamination in the
tank can cause operating problems.
Ensure that the fuel is well mixed by shaking the container
before lling the tank.
!
WARNING! The catalytic converter mufer
gets very hot during and after use. This also
applies during idling. Be aware of the re
hazard, especially when working near
ammable substances and/or vapours.
!
WARNING! Taking the following precautions,
will lessen the risk of re:
Do not smoke or place hot objects near fuel.
Always shut off the engine before refuelling.
Always stop the engine and let it cool for a
few minutes before refuelling.
When refuelling, open the fuel cap slowly so
that any excess pressure is released gently.
Tighten the fuel cap carefully after refuelling.
Always move the machine away from the
refuelling area before starting.