Husqvarna 326C, 326L, 326LS, 326LX-Series, 326LDX-Series Brush Cutter User Manual


 
English
– 11
ASSEMBLY
Fitting the trimmer head
Fitting a trimmer guard and
Superauto II 1" trimmer head
(326L, 326Lx, 326LDx)
Fit the correct trimmer guard (A) for use with the trimmer
head. Hook the guard onto the tting on the shaft and
secure it with the bolt (L).
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
•To t the trimmer head, rst separate the two halves (see
diagram). Proceed as follows:
Insert a nger into the centre hole of the cover (I) while
grasping the cover with your other ngers. Using the index
nger and thumb of your other hand, release the two
catches (J) that engage in the cut-outs in the bottom half
(K). Pull apart the trimmer head, grasping the cover rmly.
Place the cover (I) and the support ange (F) on the
output shaft.
Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool
kit. Hold the shaft of the spanner as close to the blade
guard as possible.
To tighten the nut, turn the spanner in the opposite
direction to the direction of rotation (Caution! left-hand
thread).
Fit the bottom half of the trimmer head (K) to the cover (I)
by pressing them together, with the cut-outs on the bottom
half aligned with the catches on the cover.
To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting
attachments
(326L, 326Lx, 326LDx)
Fit the correct trimmer guard (A) for use with the trimmer
head.
Hook the trimmer guard/combination guard onto the tting
on the shaft and secure with the bolt (L).
Fit the drive disc (B) on the output shaft.
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
To dismantle, follow the instructions in the reverse order.
!
WARNING!
When tting the cutting attachment it is
extremely important that the raised section
on the drive disc/support ange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is tted
incorrectly it can result in serious and/or
fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is tted this can cause serious
personal injury.
G
F
I
A
B
C
K
J
I
K
L
H
H