Filter
Top Products
28 - English
3. INSTALLATION
3.6 Installation of the guide wire
The guide wire is a wire that is laid away from the
charging station, for instance out towards a remote
part of the working area or through a narrow passage
and then connected with the boundary wire.
The guide wire is used by the mower to find its way
back to the charging station but also to guide the
mower to remote areas of the garden.
To ensure an even cut over the entire lawn, the mower
can follow the guide wire from the charging station to
the guide wire connection in the boundary wire and
start mowing there. Depending on the garden layout,
one should adjust how often the mower is to follow the
guide wire from the charging station. See
6.4 Installation (2) on page 44.
The mower must be run at varying distances from the
guide wire to reduce the risk of tracks forming when
the mower follows the guide wire to/from the charging
station. The area beside the wire which the mower
then uses is called the Corridor.
The mower always runs to the left of the guide wire as
seen facing the charging station. Thus the corridor is to
the left of the guide wire. The corridor is 50 cm wide.
When installing, it is therefore important to have at
least 75 cm free space to the left of the guide wire and
at least 25 cm free space to the right of the guide wire,
as seen facing the charging station.
It is not allowed to lay the guide wire closer than 30 cm
from the boundary wire.
The guide wire, as the boundary wire, can be stapled
to or buried in the ground.
IMPORTANT INFORMATION
Make sure that there is always at least 75 cm
of free space to the left of the guide wire as
seen facing the charging station.