Filter
Top Products
22 - English
3. INSTALLATION
Boundaries for the working area
If a high obstacle, for example a wall or fence,
borders the working area, the boundary wire should
be laid 30 cm from the obstacle. This will prevent
Automower
®
from colliding with the obstacle and
reduce body wear.
About 20 cm around the fixed obstacle will not be
mown.
If the working area borders against a small ditch, for
example, a flower bed or a small elevation, e.g. a low
verge (3 - 5 cm), the boundary wire should be laid
20 cm inside the working area. This prevents the
wheels from driving into the ditch or up onto the
verge.
About 12 cm of grass along the ditch/stone edging
will not be mown.
If the working area borders against a flat path or the
like that lies level with the lawn, it is possible to allow
Automower
®
to run a little over the path. The
boundary wire should then be laid 5 cm from the
edge of the path.
All the grass along the side of the pavement will be
cut.
When the working area is divided by a flat slab path
that is level with the lawn, it is possible to allow
Automower
®
to run over the path. It can be an
advantage to lay the boundary wire under the slabs.
The boundary wire can also be laid in the joint
between the slabs.
Note! The Automower
®
must never run over gravel,
mulch or similar material which can damage the
blades.
IMPORTANT INFORMATION
If the working area is adjacent to water
bodies, slopes, precipices or a public road,
the boundary wire must be supplemented
with a fence or the like. The height must then
be at least 15 cm. This will prevent
Automower
®
from ending up outside the
working area under any circumstances.
Min.
15cm