Filter
Top Products
14 – English
ASSEMBLY
Assembling the J-handle and off-
loading strap
!
WARNING
Only grass blades or trimmer heads/
plastic blades may be used when the J-
handle is fitted. Clearing blades must
never be used with the J-handle.
• The handlebars can easily
be turned to fit along the
shaft for easy transportation
and storage.
• Loosen the knob. Turn the
J-handle clockwise.
• Thereafter fold the
handlebars around the
shaft. Tighten the handle.
• Attach the transport guard.
Transport position, J-handle
• Loosen the knob from the
handle bracket.
• Position the handle as
shown. Fit the bracket
components and tighten
the handle lightly.
• Fit the off-loading strap
around the shaft as shown.
• Put on the harness and
secure the off-loading on
the right-hand side strap.
Adjust the length so that
the cutting equipment
balances just above the
ground.
• Finely adjust the J-handle
to give a comfortable
working stance. Tighten
the knob.
Assembly of the blade and trimmer
head
It is extremely important that
the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole when
assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
G
F
E
D
B
C
A
L
M
• The guard (A) is fitted
using 4 screws (L) and the
support plate (M) as set out
in the diagram. NOTE!
Use the recommended
blade guard.
• Fit the drive disc (B) on the
output axle.
• Turn the blade axle until
one of the holes in the drive
disc aligns with the hole in
the gear housing.
• Insert the locking pin (C)
in the hole so that the axle
is locked.
• Place the blade (D),
support cup (E) and
support flange (F) on the
output axle.
• Fit the nut (G). The
tightening torque of the
nut is 35-50 Nm (3,5 - 5
kpm). Use the socket
spanner in the tool kit.
Hold the handle of the
spanner as close to the
blade guard as possible.
The nut is tightened when
the spanner is turned
against the direction of
rotation (left-hand thread).
Assembling the blade guard and
grass blade
WARNING!
Do not attach any blade to the unit
without proper installation of all required
parts. Failure to use the proper parts can
cause the blade to fly off and seriously
injure the operator and/or bystanders.
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter
“Technical
data”
. If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
!