Filter
Top Products
English - 37
3. INSTALLATION
If you shall install the guide wire through a passage:
• Automower follows the guide wire on the same
side of the wire both to and from the charging
station. This means that in towards the charging
station the guide wire is on the right side of the
mower and away from the charging station the
guide wire is on the left side of the mower.
In the passage, the guide wire must be placed so
that the mower has as much space to run as
possible. The distance between the boundary
wire and the guide wire must however be at least
12" (see the picture above).
The same minimum distance (12") also applies
between the guide wire and the guide wire in the
passage,
Avoid laying the wire at sharp angles. This can
make it difficult for the mower to follow the guide
wire.
6. Run the guide wire to the spot on the boundary
wire where you want to make the connection.
7. Lift out the boundary wire.
8. Cut off the boundary wire using a pair of wire
cutters.
9. Connect the guide wire to the boundary wire with
the help of a solderless coupler:
• Insert the ends of the boundary wire in the right
respective left-hand holes on the connector.
• Insert the end of the guide wire in the centre
hole.
• Press down the button on the connector fully.
10. Staple down/bury the connector in the lawn.
IMPORTANT INFORMATION
The function of the guide wire varies
depending on how the working area appears.
It is therefore recommended to test the
installation with the help of the function Test
IN (3-2-4), see page 56.
3012-649
135º
135º
90º
3012-742
3012-675