Filter
Top Products
English - 23
3. INSTALLATION
3.3 Charging the battery
Automower is supplied with an uncharged battery. As
soon as the charging station is connected, it is possible to
charge the mower.
1. Set the main switch to the OFF position.
2. Place Automower in the charging station to charge
the battery while you are laying the boundary wire.
From an uncharged state the battery takes about
1 1/2 to 2 1/2 hours until it is fully char
ged.
3.4 Installation of the boundary wire
The boundary wire can be installed in one of the
following ways:
• Securing the wire to the ground with staples.
It is preferable to staple down the boundary cable,
if you want to make adjustments to the boundary
wire during the first few weeks of operation.
• Bury the wire.
It is preferable to bury the boundary wire if you
want to dethatch or aerate the lawn.
If necessary both methods can be combined so one
part of the boundary wire is stapled down and the
remainder is buried.
Best position for the boundary wire
The boundary wire should be laid so it:
• Forms a loop around the working area for
Automower. Only an original boundary wire must
be used. This is tinned and has a high quality
insulation to withstand the dampness in the
ground.
• Is a maximum of 1640 ft long.
• Maintains a maximum distance of 10 ft from
Automower in the entire working area.
• The boundary wire is laid at different distances
from obstacles depending on what the working
area borders. The picture below shows how the
boundary wire should be routed around the
working area and around obstacles.
IMPORTANT INFORMATION
Automower cannot be used before the
installation is complete.
3012-385